Concentration and subcellular distribution of trace elements in liver of small cetaceans incidentally caught along the Brazilian coast

Concentrations of trace elements (V, Cr, Mn, Fe, Co, Cu, Zn, Ga, As, Se, Rb, Sr, Mo, Ag, Cd, Sb, Cs, Ba, T-Hg, Org-Hg, Tl and Pb) were determined in liver samples of estuarine dolphin (Sotalia guianensis; n = 20), Franciscana dolphin (Pontoporia blainvillei; n = 23), Atlantic spotted dolphin (Stenella frontalis; n = 2), common dolphin (Delphinus capensis; n = 1) and striped dolphin (Stenella coeruleoalba; n = 1) incidentally caught along the coast of Sao Paulo State and Parana State, Brazil, from 1997 to 1999. The hepatic concentrations of trace elements in the Brazilian cetaceans were comparable to the data available in literature on marine mammals from Northern Hemisphere. Concentrations of V, Se, Mo, Cd, T-Hg and Org-Hg increased with increasing age in liver of both estuarine and Franciscana dolphins. Very high concentrations of Cu (range, 262-1970 microg/g dry wt.) and Zn (range, 242-369 microg/g dry wt.) were observed in liver of sucklings of estuarine dolphin. Hepatic concentrations of V, Se, T-Hg, Org-Hg and Pb were significantly higher in estuarine dolphin, whereas Franciscana dolphin showed higher concentrations of Mn, Co, As and Rb. Ratio of Org-Hg to T-Hg in liver was significantly higher in Franciscana dolphin than estuarine dolphin, suggesting that demethylation ability of methyl Hg might be lower in liver of Franciscana than estuarine dolphins. High hepatic concentrations of Ag were found in some specimens of Franciscana dolphin (maximum, 20 microg/g dry wt.), and 17% of Franciscana showed higher concentrations of Ag than Hg. These samples with high Ag concentration also exhibited elevated hepatic Se concentration, implying that Ag might be detoxified by Se in the liver. Higher correlation coefficient between (Hg+0.5 Ag) and Se than between Hg and Se and the large distribution of Ag in non-soluble fraction in nuclear and mitochondrial fraction of the liver also suggests that Ag might be detoxified by Se via formation of Ag2Se in the liver of Franciscana dolphin.     

A survey of possible impact structures on 25143 Itokawa

We determined the morphologies and dimensions of possible impact craters on the surface of Asteroid 25143 Itokawa from images taken by the Hayabusa spacecraft. Circular depressions, circular features with flat floors or convex floors, and circular features with smooth surfaces were identified as possible craters. The survey identified 38 candidates with widely varying morphologies including rough, smooth and saddle-shaped floors, a lack of raised rims and fresh material exposures. The average depth/diameter ratio was 0.08±0.03: these craters are very shallow relative to craters observed on other asteroids. These shallow craters are a result of (1) target curvature influencing the cratering process, (2) raised rim not being generated by this process, and (3) fines infilling the craters. As many of the crater candidates have an unusual appearance, we used a classification scheme that reflects the likelihood of an observed candidate's formation by a hypervelocity impact. We considered a variety of alternative interpretations while developing this scheme, including inherited features from a proto-Itokawa, spall scars created by the disruption of the proto-Itokawa, spall scars following the formation of a large crater on Itokawa itself, and apparent depressions due to random arrangements of boulders. The size-frequency distribution of the crater candidates was close to the empirical saturation line at the largest diameter, and then decline with decreasing diameter.     

Spin rates of fast-rotating asteroids and fragments in impact disruption

We present a new experimental result of fragment spin-rate in impact disruption, using a thin glass plate. A cylindrical projectile impacts on a side (edge) of the plate. Dispersed fragments are observed using a high-speed camera and the spin rates of fragments are measured. We find that the measured fragment spin-rate decreases with increasing size. Assuming that the rotational energy of fragments is supplied from the residual stress, the spin rate ω decreases with increasing fragment size r as ω∼r−1, which explains the above experimental results. This size-dependence is similar to that of the observed spin rates of small fast-rotating asteroids. Our results suggest that spin rates of fragments of small asteroids immediately after disruption may have a similar size-dependence, and can provide constraints on the subsequent spin-state evolution of small asteroids due to thermal torques.     

Development of partial factor design method on bending strength of piles for Japanese Specifications for Highway Bridges

ABSTRACT

This paper describes the development of a partial factor design method on the bending strength of piles for the Japanese Specifications for Highway Bridges. First, uncertainties in mobilised bending moments and yield bending moments were evaluated by Monte Carlo simulations. Second, the reliability of piles designed by the previous specifications were evaluated on the basis of reliability analysis considering uncertainties in the mobilised bending moments, yield bending moments, and other factors. Finally, a partial factor design method utilising a survey subsurface investigation method and ground type was developed to reach target reliability levels determined by the Standards.     

Duluth Complex apatites: Age reference material for LA–ICP–MS‐based fission‐track dating

Anorthositic series apatites of the Duluth Complex, Minnesota, USA, have high spontaneous fission‐track densities of up to ~10⁷ cm^–2 and a homogeneous age of ~900 Ma, allowing high‐precision fission‐track dating based on LA–ICP–MS U analysis. Absolute fission‐track dating, track‐length measurement and chemical composition analysis were performed to evaluate a cooling history, which is essential for age reference materials. Preliminary inverse modelling for a sample with a shortened track‐length distribution yielded a monotonic cooling history from ~100°C at 925 Ma. The apatites incur an over‐etching problem when employing the commonly used etching protocol involving 5.5 M HNO₃.